Highway Code Rule 303
Tram stops. Where the tram stops at a platform, either in the middle or at the side of the road, you MUST follow the route shown by the road signs and markings. At stops without platforms you MUST NOT drive between a tram and the left-hand kerb when a tram has stopped to pick up passengers. If there is no alternative route signed, do not overtake the tram – wait until it moves off.
Law
Section: Road works, level crossings and tramways (rules 288 to 307) Subsection: Tramways (rules 300 to 307)Highway Code Rule 304
Look out for pedestrians, especially children, running to catch a tram approaching a stop.
Section: Road works, level crossings and tramways (rules 288 to 307) Subsection: Tramways (rules 300 to 307)Highway Code Rule 305
Always give priority to trams, especially when they signal to pull away from stops, unless it would be unsafe to do so. Remember that they may be carrying large numbers of standing passengers who could be injured if the tram had to make an emergency stop. Look out for people getting off a bus or tram and crossing the road.
Section: Road works, level crossings and tramways (rules 288 to 307) Subsection: Tramways (rules 300 to 307)Highway Code Rule 306
All road users, but particularly cyclists and motorcyclists, should take extra care when driving or riding close to or crossing the tracks, especially if the rails are wet. You should take particular care when crossing the rails at shallow angles, on bends and at junctions. It is safest to cross the tracks directly at right angles. Other road users should be aware that cyclists and motorcyclists may need more space to cross the tracks safely.
Section: Road works, level crossings and tramways (rules 288 to 307) Subsection: Tramways (rules 300 to 307)Highway Code Rule 307
Overhead electric lines. Tramway overhead wires are normally 5.8 metres above any carriageway, but can be lower. You should ensure that you have sufficient clearance between the wire and your vehicle (including any load you are carrying) before driving under an overhead wire. Drivers of vehicles with extending cranes, booms, tipping apparatus or other types of variable height equipment should ensure that the equipment is fully lowered. Where overhead wires are set lower than 5.8 metres, these will be indicated by height clearance markings – similar to ‘low bridge’ signs. The height clearances on these plates should be carefully noted and observed. If you are in any doubt as to whether your vehicle will pass safely under the wires, you should always contact the local police or the tramway operator. Never take a chance as this can be extremely hazardous.
Section: Road works, level crossings and tramways (rules 288 to 307) Subsection: Tramways (rules 300 to 307)